Web Redirect URL Configuration

Azure App Registration

1. Go to Azure Portal and Locate Your App Registration

   • Log in to the Azure Portal.

   • Navigate to Azure Active Directory.

   • Click on App registrations.

   • Select the application that you want to configure (or create a new registration if you haven’t done so already).

2. Add a Web Redirect URL

   • Once inside the app registration, go to the Authentication section on the left-hand menu.

   • Under the Redirect URIs section, click Add a platform.

   • Select Web as the platform type

   • Enter your Redirect URL in the Redirect URIs field.

   • This URL should match the address where your application will receive responses from the Azure authentication service. For Example:

https://yourappdomain.com/auth-response

• Click Configure to save the web platform.

1. Review the Redirect URL Format. The Redirect URL must meet the following requirements:

   • It should start with https:// (for web apps).

   • Localhost URLs are allowed for testing (https://localhost:1234), but if your app is intended for production use, make sure it’s set to a secure, valid URL.

2. Save and Verify

   • Click Save to finalize your changes.

   • Verify that the Redirect URL appears correctly in the Authentication section.

3. Check for Multiple Redirect URIs (If Applicable)

   • If your application uses multiple environments (e.g., development, testing, production), you can specify multiple redirect URIs by clicking Add URI in the Redirect URIs section.

   • Each URL should point to the corresponding environment (e.g., https://dev.yourapp.com/auth, https://test.yourapp.com/auth, https://yourapp.com/auth).

   Example of a Configured Redirect URI in App Registration:

https://myapp.com/signin-oidc